If you’ve added a WSM in the app that you’d like to remove you can find instructions here for how to do so.
If you’ve added a WSM in the app that you’d like to remove you can find instructions here for how to do so.
If your WSM has lost internet connection you can read more here on how to get it back up and running.
You may find that you need to do a factory reset to your WSM. If this is the case, read along here to find out how.
Looking for help connecting your WSM-252W to WiFi? Follow along here for support.
If you believe that your floor probe readings are inaccurate or if you are getting an ER1 message, you may want to test your floor probe. Learn how-to here.
Warmup recommande de tester vos câbles de chauffage par le sol avant, pendant et après l’installation. Suivez ce post pour obtenir du soutien.
Warmup recommends testing your underfloor heating cables before, during, and after installation. Follow along with this post for support.
It is important to test underfloor heating cables before, during, and after installation with the proper equipment. Read on here for our recommendations.
You may need to change the setting for the “Low Temperature Cutoff – LTC.” Click “Read More” for an explanation.
The ER1 message will also occur if no floor sensor is connected to the thermostat. Have your electrician make sure that the sensor probe wires are securely connected in ports 1 and 2 of the thermostat. If sensor was not installed, your thermostat can be programmed to read the air temperature instead by following the steps below.